What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 08:37

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
The third is lightning and “how it gets conducted into a home.”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
(Dc diagram shown, AC is similar).
One is “what exactly is in a ‘surge protector’ ? ”
The bolt then partially travels down the line to your home.
Pocket is shutting down, so I switched to a self-hosted alternative - Android Authority
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
but I think this circuit , shows a few more pieces.
Edit 2024–10.
‘Resident Evil Requiem’ Sets February 2026 Release From Capcom - Variety
At one ohm, the resistor has a maximum of 1 watt power.
This is where the MOV conducts again, and dissipated the energy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
NASA Discovers Strange X-Shaped Structures in Earth’s Upper Atmosphere - Indian Defence Review
so, what happens?
What is lightning?
A circuit breaker is similar, but is resettable.
Did Obito ever fully redeem himself in everyone's eyes?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The MOV will conduct when the voltage exceeds 50% of line voltage.
For this case there are devices called Metal oxide varistors (MOV).
Does meth make women super horny like it does men?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
A fuse is a non-resetable over current circuit protector.
I post the exact comment here.
Have you ever had a secret crush on anyone?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This device then solves the entire problem.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Scientists discover a 33-foot Jurassic giant, twice as big as its cousin - Earth.com
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
This is 'the assistant's answer'
Samsung Galaxy S26 Ultra to continue trend of disappointing batteries - PhoneArena
An AC voltage/ current source, and an ac inductive load.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
These are simplified answers to the original question, and does not change anything I wrote above.
ETH, SOL 'very rare' staking ETFs may launch imminently — Analysts - Cointelegraph
Because the load is inductive, the current lags the voltage.(by a bit).
This one hit behind the barn.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
These devices are installed between the “hot” and “neutral” and protective ground.
But it can get overloaded, and no longer works.
He then describes Rainy Season and Lightning.
There are two important concepts here.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
First Sentence:
eight
But… the neutral is now “floating” because of the 1 ohm resistance.
He then describes the function of a fuse.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Barnstars:
[old diagram got deleted by accident]
2024–10–14 [Omar Gharbi Omar Gharbi ]
The other is “what does a “fuse” do?”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is where this question deviates from being a 'generic' question, and becomes more specific.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Here is a simplified AC power diagram.
2024–10–16 [ OO OLAOYE OYEBODE ]
a photo is worth a thousand words.
but this device (an Inductor) … impedes the rapid changes in the current.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–10[John johnson John Johnson ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
nine
It seems Mohan does not understand the difference between a comment and an Answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
the problem then depends on "how fast does the fuse operate?".
[image of Common-mode choke]
What does a fuse do?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Now when you have a certain ac resistance, then a current flows in a loop.
what exactly is a ‘surge’ protector?
At least they know the answer if they wanted it.
In schematic diagrams this is the symbol for a fuse:
One
He then asserts :
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
It also is a device that limits the change in current flow.
There are three different concepts here that are getting confused.
Upvotes:
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”